Sound Blaster

[CBR]

Does anyone know what the (FACTORY/DEFAULT) jumper settings (other than JP1)

are for the Audigy Platinum front panel (Model: SB0010) (Circuit Board: SB0010D)?

While servicing my PC, I noticed a loose jumper flopping around inside the front

panel (It's not JP1). I think it might be (JP6), but I'm not 100% sure. I've tried

technical support but all I get is the (lazy-tech) run-around. After acknowledging

that I needed the factory/default jumper settings, they referred me to the manual

(all it gives is JP1) and some article on jumper settings (no Audigy front panel

jumpers listed). I've searched the Knowledge Base, these boards, and Google

until blue in the face.

I could care less what these jumpers do (Creative can keep their secrets).

I don't care about tweaking or testing anything. All I need is the Factory/default

settings (other than JP1).

=====================================

A (clear) screenshot would do, but I would prefer just a hand-written explanation.

EXAMPLE...
FACTORY/DEFAULT JUMPER LOCATIONS:

                    [ ^ Front of Panel ^ ]

(JP6)   = top two...or...bottom two...or...none,

(JP7)   = left two...or...right two...or...none,

(JP9)   = 3rd pair from left,

(JP10) = on/off,

 etc., etc....

=====================================

Thanks,
CBR

Message Edited by CBR on 04-21-2006 02:28 PM

[CBR]

I finally found what I was looking for...

   [ ^ FRONT OF PANEL ^ ]

(JP6)   = Rear Two Jumpers

(JP7)   = None

(JP9)   = 3rd pair from left

(JP10) = None

See this forum for pictures:

http://www.dslreports.com/forum/remark,15802497

Later,

CBR

[Vinn1]

Hi im after the or a copy of the install disks and sofware for the same Audigy can you help please Cheers Vince